Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
TECH
General Tech
couple issues
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="svt slobra" data-source="post: 1210581" data-attributes="member: 16507"><p>ok guys,</p><p>today i got a trick flow intake plenium and throttle body. after installing it on my 2000 gt, it seems to have an idle hang issue and a stalling issue at stop lights. i cleaned the egr,replaced the vac lines and made sure everything was sealed. drove the car around the block and its still acting up. it also runs rich i believe(little bit of a backfire/pop on shifts)</p><p></p><p>this set up worked flawlessly on my black gt, so i really doubt its the plenium or TB....but my car did run good before i installed these</p><p></p><p>could an o2 sensor cause this? i had a cel turn on for a min and then go out the other day. ran the stored code and it came back as bank 1 sensor 1 malfunction.</p><p></p><p></p><p>and issue number 2.......</p><p></p><p>for some reason i have no cluster or heater control lights with the dimmer switch......all controls work great and guages all work.....any ideas on that?</p></blockquote><p></p>
[QUOTE="svt slobra, post: 1210581, member: 16507"] ok guys, today i got a trick flow intake plenium and throttle body. after installing it on my 2000 gt, it seems to have an idle hang issue and a stalling issue at stop lights. i cleaned the egr,replaced the vac lines and made sure everything was sealed. drove the car around the block and its still acting up. it also runs rich i believe(little bit of a backfire/pop on shifts) this set up worked flawlessly on my black gt, so i really doubt its the plenium or TB....but my car did run good before i installed these could an o2 sensor cause this? i had a cel turn on for a min and then go out the other day. ran the stored code and it came back as bank 1 sensor 1 malfunction. and issue number 2....... for some reason i have no cluster or heater control lights with the dimmer switch......all controls work great and guages all work.....any ideas on that? [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
Driveshaft and Ring&Pinion recommendation
Latest: GTamas
Today at 2:10 AM
Drivetrain
What Did You Do To Your Car Today?
Latest: 07GtS197
Yesterday at 8:18 PM
The Garage
G
Ford Carlisle
Latest: gatorblue92
Yesterday at 6:34 PM
Regional Meets, Chat, and Events
V6/GT rear spoiler 94/95?
Latest: shovel
Yesterday at 1:56 PM
Exterior and Interior
S
Gear Ratio Change & Speedometer Correction
Latest: SPeace-ATL
Yesterday at 1:51 PM
Drivetrain
Share this page
Reddit
Pinterest
Tumblr
WhatsApp
Email
Share
Link
Forum statistics
Threads
78,527
Messages
1,535,650
Members
16,185
Latest member
dmen76
Members online
ttocs
Forums
TECH
General Tech
couple issues
Top