Reply to thread

Message: <blockquote data-quote="Raffaelli" data-source="post: 1138611" data-attributes="member: 12402">To run a edis waste spark system on a 5.0 you will need... To mount a 36-1 trigger wheel and a vr sensor on the crank and properly phase it.  remove the dizzy or use explorer cam sensor and use that as a oil pump drive wire up the edis 8 properly. Your PCM might be able to be re programmed to run off o edis, but you will probably loose sequential fuel injection. If you ran a megasquirt processor, you can run edis, coil on plug (or like ls motors) and retain full sequential fuel an ignition timing. The ecc 4 processor could run edis, but its not optimal.there is much more to it than running a cam sensor. (Which is a on/off switch for cam position anyway.</blockquote>