Reply to thread

Message: <blockquote data-quote="tooslow" data-source="post: 267664" data-attributes="member: 9239">the SVO/FRPP blower is a non intercooled eaton m90. this is an intercooled Eaton m112. its also a magnuson housing, which is MUCH MUCH more effecient than even a ported term cobra eaton housing.like i just said, it more effecient than the typical eaton m112 found on cobra's. and that hasn't stopped anyone from buying a cobra has it?Also, its modeled after the cobra lower intake. meaning you could take the Maggy off, and put on the whipple/Kenne Bell of your choice.hell, after the blower swap you can sell the maggy on E-bay and offset half the price of the kit.about the rotrex/centri blowers. for $4k you'd be hard pressed to get a blower that performed as well as this would. it can easily support 500hp, many 03/04 cobra's have proven this. plus you get the instant responce of a PD blower. this blower is more than enough for any stock block 2v. unless you feel your stocker is up to the tast of holding 500+hp.  :santa_evil:no, it isn't the greatest blower. a KB twin screw would be better, but for almost $3k more. but if it is in fact the same pattern as the 03/04 cobra lower than any term blower can be fitted to it. <--- that is why this is a good kit.link to the kit.<a href="http://www.torktech.com/index.asp?PageAction=VIEWPROD&ProdID=2" target="_blank">http://www.torktech.com/index.asp?PageAction=VIEWPROD&ProdID=2</a></blockquote>