Reply to thread

Message: <blockquote data-quote="94kingcbra" data-source="post: 505445" data-attributes="member: 9140">Sounds like you have corrosion somewhere in the circuit. First check your battery terminals, and make sure that the ground has a clean and solid connection. After that pull each connector in the circuit and look at the connections inside them. A sharp pick can clean up the female connectors and a simple wire brush will help with the male connectors...Another thing you can do with a digital multimeter is test the resistance of the wire from connector to connector....If you have alot of resistance in certain area, there in lies your problem...When doing resistance testing remember that there should be no power in the circuit, and your digital multimeter should be set to Ohms. Another thing you can do is a pinpoint voltage test. This is where you place the ground in one location, and with power going through the circuit, you test the voltage at each connector, if there is a major difference, then whatever is between your last one is probably your problem...I wish I could be there to help...These intermittent problems can be very hard to find....Good Luck</blockquote>