Reply to thread

Message: <blockquote data-quote="Snorky" data-source="post: 1503728" data-attributes="member: 29157">I have been very busy working on my tuRbo car.. which i will make a thread about soon. So since i have a lot of waiting to do on critical engine components, i have decided to address other critical areas. Namely the fuel rails.  So i ordered 5 ft of 8 AN fuel rail extrusion and a 14mm O ring injector contour mill.  [ATTACH=full]18371[/ATTACH]Next I measured out the spacing and offsets on my 4.6 divisionX rails.  Fixtured the rails in the bridgeport and got to work.   I really want to make 8 an ORB fittings, but the 9/16  contour mill to do the job is stupid expensive, so i will probably just tap it 3/8 NPT instead.    Until i make that decision I will test fit the rails and sketch out some brackets to make. As well as check to see if they will clear COPs.. if not i may have to mill clearance slots in them.   I will also consider doing this same process to some 6AN extrusion so i can have some options since these 8AN rails are overkill. [ATTACH=full]18372[/ATTACH][ATTACH=full]18373[/ATTACH][ATTACH=full]18374[/ATTACH]</blockquote>