Reply to thread

Message: <blockquote data-quote="Snorky" data-source="post: 1513477" data-attributes="member: 29157">Ask and you shall receive. This post is picture heavy.. like very heavy lolAlright, so I started on the lower seat, only half way finished with the stays.. I ran out of nylon string. So hopefully a store will be open to get some. And while I am out I will pickup the upper seat frame so I can do the top portion too. Anyway.. here goes.Step one.. cut a metal hanger and bend it to make some threading needles...[ATTACH=full]22473[/ATTACH]So in the forward to backward runners, a 13" stay rod is placed, the back side of the rod should basically be 3/8" behind the rear left to right stay.   The front to back ones when pulled will forced the three left  to right stays down into their grooves respectfully.[ATTACH=full]22474[/ATTACH][ATTACH=full]22475[/ATTACH]End of the rod is about where my finger is. Use the threading rod to pierce the fabric over the rod and pull the string through. Rethread the needle and send it straight through.  [ATTACH=full]22476[/ATTACH][ATTACH=full]22478[/ATTACH]Pull  semi tight and tie it around a piece of plastic like seen in the later pics. The first one I did about 1/2" behind the left to right rod.  The second about 1/4" in front of the rear left to right rod. [ATTACH=full]22480[/ATTACH][ATTACH=full]22479[/ATTACH]And the third an inch back from the front of the rod.[ATTACH=full]22481[/ATTACH][ATTACH=full]22482[/ATTACH][ATTACH=full]22483[/ATTACH]</blockquote>