Reply to thread

Message: <blockquote data-quote="Snorky" data-source="post: 1554302" data-attributes="member: 29157">Remembered the drill bit from work yesterday. The 10-32 wood inserts needed  a 9/32 bit.   So I marked out and installed the  inserts for the amplifier[ATTACH=full]39013[/ATTACH]Then installed as such [ATTACH=full]39014[/ATTACH]Then I measured out how I wanted to lay the sub on the board.  Although ttocs being 100% right about the orientation. It would unfortunately make using tye trunk a bit more challenging. I will give this setup a go. If I hate it. I'll go with ttocs advice.  Hard part is finished. Ie. The big floor board lolAnyway. Drilled pilot holes and used flat head wood screws from underneath to secure it.[ATTACH=full]39015[/ATTACH] The mounting board is roughly laid ou over the floor for round about representation.[ATTACH=full]39016[/ATTACH]</blockquote>