Reply to thread

Message: <blockquote data-quote="Snorky" data-source="post: 1572376" data-attributes="member: 29157">Well the shipping email hit for the LAR O/R stainless X pipe.  [ATTACH=full]44128[/ATTACH]Since it does not appear to have a thermactor pump tube. I decided I should pull the stuff out(not hooked up with a belt from the previous owner anyway)  I also decided it was time to pull the tranny to fox the spedo gear. So out the trans came.[ATTACH=full]44130[/ATTACH]I will remove the tailshaft housing and fix the speedo gear perhaps tomorrow if the weather permits.  While I was in there I removed the smog pump setup. This will go on the shelf in case i or someone else down the road needs it.  [ATTACH=full]44129[/ATTACH]I am frankly shocked at how large that system is.  I still need tk block off the 2 vacuum lines and place plugs into the back of the heads.  I grabbed some 5/8-11 set screws, but I can only get the passenger side started and only goes 2 turns before it seems to hit build up city. I may try to chase the threads if i can find a tao,but i doubt i have room to get one in there.  I might slot a set screw and try using that as a pseudo tap.The drivers side i can't even get started. Open to ideas if you have them.  [ATTACH=full]44131[/ATTACH] [ATTACH=full]44132[/ATTACH]</blockquote>