Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1150280" data-attributes="member: 11896">ah ok I thought you were trying to get the euros to look like the imports.  There are two small spots on the back of those bottom section on my 94 where a bulb would go.  Not sure what light you want to put in there though as it would take a little time to cut out the hole and the notch for the standard lights and then you don't have anything to keep it from spinning and locking into place.  you might consider just getting 5-10 3-5mm led lights to put in the back of each section to light up the lower portions.  All you would need to do there is drill a small hole, put the led mounting ring into it and then the led to the ring and your done.  I still think it will be harder then you think to polish out the reflectors and make it look good.  Also be carefull to not scratch the outside of the lense any further while sanding those out.  Put a layer of tape on it and it will keep any further scratches from needing to be polished out later.  I think I would recommend you make one with the reflectors in and just do not glue it all back together to test it out.  This way you will know what to expect from them being in there and you can keep them if they work.  But obviously if you sand one out and end up not happy with it you will need to order another set of lights to start over again.</blockquote>