Reply to thread

Message: <blockquote data-quote="ThA SkInNy" data-source="post: 1030762" data-attributes="member: 16625">I've been collecting parts for a little while now and I and getting ready to put the newer motor and trans in my 95. While I am pulling it I am going to add the parts I have and have been collecting over the last few months. Is not much but should make the car fun!Here's a list of what will be going on:Stock bottom end and cam 5.0Gt40p heads (looking into roller rockers just not sure of ratio)Gt40 explorer intakeTrick flow elbowTrick flow under drive pulleysMac shorty p headersBBK stainless O/R x pipeMSD 6al ignition setupSub frame connectorsCenterforce HDX Steeda cable and quadrant4:10'sFor exhaust I have 2 options I have a set of super 44's and a set of stainless works race mufflers from a gt500 kit. Regaurdless It will be a dumped exhaust system. I'm just not sure which ones to go with.What compression ration can i expect with the P heads and I'm also kinda wondering what kind of power I might expect to see ...lol Any ideas or input at all is appreciated.<a href="http://www.flickr.com/photos/43445913@N03/7674104744/" target="_blank">http://www.flickr.com/photos/43445913@N03/7674104744/</a><a href="http://www.flickr.com/photos/43445913@N03/7674106062/" target="_blank">http://www.flickr.com/photos/43445913@N03/7674106062/</a>I posted in the intro section and had some tech questions so I just copied and pasted... LolI'm wanting to know what is the recommended spring to use for the setup I'm putting together... I definetaly want it to rev but I'm not sure if I'm going roller rocker orcnotvjust yet. Any help is greatly appreciated! Thanks</blockquote>