Reply to thread

Message: <blockquote data-quote="Blind" data-source="post: 876767" data-attributes="member: 10282">brake line mods on a `97, your T will be in the center rather than on the passenger side, the idea is the same you'll just need different length lines.<img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_0113.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /><img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_0112.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />cradle bolts, the ones going straight up had to be drilled, I dropped my gas tank to give me room for my large drill, so I replaced the fuel filter, fuel pump, and fuel filler tube gasket on the side of the tank while I was at it.<img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_1758.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /><img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_1761.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /><img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_1762.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />ABS sensor wires come through the floor under the back seat lower cushion -<img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_1743.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />I had to drill out the chassis of my car where the front of the IRS bolts to, in order to use the larger 14mm bolts that are recommend to reduce the 'cobra clunk' while shifting, as the smaller bolts can let the front of the IRS unit move slightly.(stock SRA bolt on left, larger IRS specific front bolt on right)<img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_1751.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />easiest way to install the unit is to bolt in the front first -<img src="http://i40.photobucket.com/albums/e237/blindbatts/97gt/IRS/IMG_1752.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />And use a jack under the pumpkin to swing the rear of the cradle up into the brackets.</blockquote>