Reply to thread

Message: <blockquote data-quote="95PGTTech" data-source="post: 586012" data-attributes="member: 9525">You truly wasted your time if you did not degree them. Other than not being optimized as far as power production, I guarantee there is a few degrees difference between the two sides of the motor. I've seen as much as 10 WHEEL horsepower from degreeing STOCK modular cams properly, along with the obvious driveability improvements.All modular cams need to be degree'd in. There is no way to just throw them in and install them "heads up." This is not a pushrod motor where even if the cam is not degree'd properly at least both sides of the motor are off the same.</blockquote>