Reply to thread

Message: <blockquote data-quote="97stanger" data-source="post: 935195" data-attributes="member: 8229"><p>thanks a lot guys.  I just never liked the look where you see the huge cut through the interior panels, so we installed the roll bar for measurement purposes, took it out, cut it off from the plates at the bottom past the point of the inner panels, had powder coated, reinstalled and slid the interior panels on the bars, than had re-welded to the plates and simply slid the inner panels down into place (hope that made sense).  Definitely more work but I think completely worth it in the end</p></blockquote><p></p>