Reply to thread

Message: <blockquote data-quote="lwarrior1016" data-source="post: 1497379" data-attributes="member: 20210">So I’ve had a one touch module for my passenger window for a few years now and just got around to installing it. When I got the module, the write up was still alive on mustang world, now it is gone. So I’m doing a semi-write up on it with a couple pictures for future reference. First thing, acquire a module from the driver door of a mustang at the junkyard, make sure to cut some of the harness out of the donor car. Remove the passenger door panel completely. Then strip back some of the tape on the window switch harness. [ATTACH=full]15339[/ATTACH]We are going to use red/yellow, black, blue/black, and yellow/red. The only circuit that needs to be broken is the red/yellow wire. This one will get cut and two wires from the module will connect to them. The red wire from the module harness goes down to the window motor, and the white wire from the module goes up to the switch like shown below. [ATTACH=full]15340[/ATTACH]Now the rest of the wires will just be spliced in to the circuit with corresponding colors. Black goes in the black wire, blue goes to the blue/black wire, and yellow goes in the yellow/red wire. I chose to solder and heat shrink mine, but you can use butt connectors if you’d like. Just make sure they have adhesive shrink tubing on them. [ATTACH=full]15341[/ATTACH][ATTACH=full]15342[/ATTACH]And that’s it for wiring. Now the window goes down with one touch from the driver and passenger switch.</blockquote>