Reply to thread

Message: <blockquote data-quote="mustangspartan" data-source="post: 854153" data-attributes="member: 9864"><p>From the look of it seems like its still off a little but better for sure. When you did the measurements did you do the underside only? I would check also the position of the mounts for the A arm and the geometry of the whole front end. The stock a arms should be fine unless they are bent.. The c/c plates shouldnt make a difference your not moving the wheel back from the mounted position at the end of the A arm so it should only effect the position of were the steering pivot point and the pitch in and out on the vertical access of the wheel. Check both sides of your wheelbase that should be your next move then proceed to the geometry.</p></blockquote><p></p>