Reply to thread

Message: <blockquote data-quote="GregT94SCC" data-source="post: 1436223" data-attributes="member: 9734">I've been running a Kenne Bell since 08 and have 30k on the setup.  Learning how to get it right cost me a shortblock, albeit one I built to be fairly high compression.  I run the 94 cobra cam with 1.7 roller rockers.  It will run right through redline so I added an MSD with a rev limiter (a CD box is needed for the KB setup anyway) to keep me honest.  I don't have an intercooler (not sure how you would plumb one in) so it took quite a bit of tuning to keep the motor happy.  It gets hot and stays hot after spirited use.I run the LMAF as I found I could peg the smaller ones and despite its size, metering is sufficient at lower RPMs,  All in all I am happy with the setup and other than it being way too much power off the line (3:73s don't help) it pulls hard and is very low maintenance, just make sure you change the oil at the recommended interval and keep the belt tight. Do you need a copy of the installation manual?</blockquote>