Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1045484" data-attributes="member: 11896"><p>I have been wanting to replace the strut tower brace I had to remove when I put my heads on and needed a spacer to clear them.  I bought a steeda brace used but was suprised to see that it still hits on the back drivers side of the cobra intake I am running.  If I were to cut that piece off it would fit and might be able to get a bent piece welded on later but it would stiffen it up and be better then nothing?  I even considered cutting the other back side/back half off so its just the piece between the towers, again better then nothing but what would you do?</p></blockquote><p></p>