Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1201485" data-attributes="member: 11896">went to the body shop today to see if they had time to do the core support and of course they are busy.  Went and ordered the core support, also stopped by pivco to get some filler/sanding blocks and then to harbor freight.  I have been wanting a tool-roll-around/dolly to have a place to put tools down while working rather then on/around/under the car.  They had this one marked down from $259 to 150, $110 with coupon.  Gives me some space to grow into and plenty of space to work.<img src="http://carphotos3.cardomain.com/images/0016/43/89/16313498_large.jpg?v=1" alt="" class="fr-fic fr-dii fr-draggable " style="" />Not gonna lie, was feeling good and wanting to do something on the car mainly some welding so I figured I DON'T NEED NO STUPID ANTENNA!!!  I started off by putting masking tape over the hole and then carefully cut the hole out so I had a pattern to use. <img src="http://carphotos.cardomain.com/images/0016/53/50/16313505_large.jpg?v=1" alt="" class="fr-fic fr-dii fr-draggable " style="" /> I put the tape down on the other fender on the other side about the same location so the bend would be the same and then carefully cut it out. <img src="http://carphotos2.cardomain.com/images/0016/53/80/16313508_large.jpg?v=1" alt="" class="fr-fic fr-dii fr-draggable " style="" />After cutting it out I used magnets to hold it in place so I could weld it.<img src="http://carphotos.cardomain.com/images/0016/53/90/16313509_large.jpg?v=1" alt="" class="fr-fic fr-dii fr-draggable " style="" />after some sparks.<img src="http://carphotos4.cardomain.com/images/0016/53/02/16313520_large.jpg?v=1" alt="" class="fr-fic fr-dii fr-draggable " style="" />I was able to fill one of the mounting holes but not the other two.  Should I just throw a screw in them and then tach them or or wad up some welding wire?<img src="http://carphotos3.cardomain.com/images/0016/53/32/16313523_large.jpg?v=1" alt="" class="fr-fic fr-dii fr-draggable " style="" />Needs some more sanding work and then a thin layer of putty(after the rest of the fender is stripped) and WHAT ANTENNA?!  Going to start stripping the trunk lid so I can mold the S281 spoiler and the license plate frame-thingy.  Was looking for panel bonding adhesive today and it seems only napa has it available and its $60 for the tube and $85 fore the special gun that mixes the epoxy as it exposes it.  Anyone have any other suggestions?  I need to bond the S281, license plate frame and the shinoda chin to the front bumper so $60 a tube I might start to look at a case to cover the area I need too..</blockquote>