Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Engine Specific Tech
94-95 5.0 - Specific
Welp, tried installing some BBK long tubes...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="OnyxCobra" data-source="post: 582087" data-attributes="member: 8293"><p>After talking with a few guys on here about installing fox body long tubes i had confidence that these would fit without much trouble; to say the least they don't fit. I think it may be because everyone i talked to had 1 5/8 headers and mine were 1 3/4, i don't know. First thing i noticed was i had to remove the clutch fork cover to get them to bolt into place. After they were bolted in the steering shaft would not reconnect. I unbolted the header and lifted it up to make room to connect the steering. After the steering was connected the header would not fit back into place. I didn't even bother with the passenger side at that point. I'm not one that likes to bang and bend stuff to make parts fit so i'm just going to resell them and buy some for a 94/95 i guess...</p><p></p><p>Just wanted to give everyone a heads up, too bad too cause after a little polish they looked pretty sharp!</p></blockquote><p></p>
[QUOTE="OnyxCobra, post: 582087, member: 8293"] After talking with a few guys on here about installing fox body long tubes i had confidence that these would fit without much trouble; to say the least they don't fit. I think it may be because everyone i talked to had 1 5/8 headers and mine were 1 3/4, i don't know. First thing i noticed was i had to remove the clutch fork cover to get them to bolt into place. After they were bolted in the steering shaft would not reconnect. I unbolted the header and lifted it up to make room to connect the steering. After the steering was connected the header would not fit back into place. I didn't even bother with the passenger side at that point. I'm not one that likes to bang and bend stuff to make parts fit so i'm just going to resell them and buy some for a 94/95 i guess... Just wanted to give everyone a heads up, too bad too cause after a little polish they looked pretty sharp! [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
What Did You Do To Your Car Today?
Latest: 07GtS197
Today at 8:18 PM
The Garage
G
Ford Carlisle
Latest: gatorblue92
Today at 6:34 PM
Regional Meets, Chat, and Events
V6/GT rear spoiler 94/95?
Latest: shovel
Today at 1:56 PM
Exterior and Interior
S
Gear Ratio Change & Speedometer Correction
Latest: SPeace-ATL
Today at 1:51 PM
Drivetrain
Driveshaft and Ring&Pinion recommendation
Latest: 96blak54
Today at 12:04 PM
Drivetrain
Share this page
Reddit
Pinterest
Tumblr
WhatsApp
Email
Share
Link
Forum statistics
Threads
78,527
Messages
1,535,647
Members
16,185
Latest member
dmen76
Members online
ttocs
wmfateam
Forums
Engine Specific Tech
94-95 5.0 - Specific
Welp, tried installing some BBK long tubes...
Top