Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 999794" data-attributes="member: 11896">all I would be doing is cutting some foam, guing that to the board before I went over it with the black/green material.  The green is just a 1" stripe down the middle.  The design/logo would just be a slightly raised section.  My thought is that if someone sat down and then happened to look up, first they would see the stripe/microsuede and only then if its done right would then notice the raised design.  Now that I think about it if I am going to go overboard on some part of my car the headliner would be the place since not many would see it.Recently I thought about raising the stripes, and then cutting out the mustang GT logo the same way in the rear bumper, just behind the visors.</blockquote>