400rwhp stock bottom end

joshmartin · Jan 21, 2008

is there anyone on here with 400rwhp on a stock motor? im going to dyno sat for a dyno tune and thats what im aiming for....

full pi swap with aftermarket cams , bbk 75mm tb , c&l upper plenium , C&l cold air , mac xpipe with flow master 1 chambers ... a dyno tune by prodyno in southcarolina and a 150 shot ftw!!!! 400 is our goal .... should make around 275 or so on motor so 150 shot on that should be close

imp2:

94darkhorse · Jan 21, 2008

Good luck

Lightning Struck · Jan 21, 2008

I do, but I dont think Mine would count :rolleyes2:

joshmartin · Jan 21, 2008

lol :noes: :bunny3:

96GT · Jan 21, 2008

I wouldn't recommend going for such power with the 150 shot for obvious reasons.

joshmartin · Jan 22, 2008

lol itll be alright my friend has a 700whp 2 valve and he owns a shop that builds mustangs and he sprayed 150 on his 96gt for 2 years hahah then again he was lucky maybe hahaha if it blows oh well :happydrunks:

MustangMatt96GT · Jan 22, 2008

I will soon have a 400 horsepower on spray too!

97stanger · Jan 22, 2008

im at 370rwhp, 380tq and doing cams very soon and hopefully in the 410rwhp range

AaRoN · Jan 22, 2008

blown97stanger said:
im at 370rwhp, 380tq and doing cams very soon and hopefully in the 410rwhp range

What cams are you going with? (I know you mentioned it somewhere... :uglystupid2

97stanger · Jan 22, 2008

I'm getting custom grind non pi supercharger cams done by Tim at Modular Power House. I'll also be doing some new springs and Team Breed valve covers :thumb:

AaRoN · Jan 22, 2008

Sounds like a good setup

imp2:

voidfinger · Jan 22, 2008

I'm thinking of going with a 125 or a 150 shot on my car down the road after the pi swap. One word though and live by it... "TUNE" . Make sure you have a safe tune for it, no matter if its shy of your 400 power dreams... also, make sure you have all the safty stuff for it ok. that would be nasty to have it blow on you b/c of a fuel problem or under wot runs.