95 obd2 issue

[Mustang5L5]

It is a 95 but I’m sure it’s obd2 under the dash that’s what the dealer told me I just can’t find the fuse for the port

So have you checked the fuse I show in post #7?

 

[RAU03MACH]

The one under my dash dose not work

I tried my blue tooth scanner on it no go
So on 5.0 it doesn't respond
Well I'll be covering over to the megasquirt computer soon
And the EEC won't be needed

 

[ttocs]

5.0 has the connector as they were expecting to switch over sooner than later, but they are not connected to anything

 

[Kyle89]

1994-1995 V6 Mustangs are in fact OBD2 and have a connector under the dash. The 5.0 cars do have the connector, but it's not functional. Need to pull codes on those cars under the hood.


The fuse for the OBD2 diagnostic port is also the same fuse as the cig lighter, so check to see if this fuse has blown. Yellow one highlighted below
View attachment 34940


It's a very primitive form of OBD2 so don't expect to see a lot of PID's like something made in the last 10 years.

I’ll check and replace anyway but it looked good before my first fire up

 

[Kyle89]

Off topic but does anyone know where I can order the transmission cooler lines ? Mines leaking at the trans and before I fully bolt my exhaust on I need to replace them and can’t find them anywhere

 

[RAU03MACH]

i dont think you can get them new
MPS
might have a good used set
if you have the right fittings you could make the lines yourself
seen one guy do it with braided hose and fuel fittings

 

[Kyle89]

i dont think you can get them new
MPS
might have a good used set
if you have the right fittings you could make the lines yourself
seen one guy do it with braided hose and fuel fittings

I was worried someone would say this lol do you know if the 5.0 lines are the same ?

 

[RAU03MACH]

i want to say yes
it should be
but the fittings are different