Reply to thread

Message: <blockquote data-quote="SRT Handz" data-source="post: 434506" data-attributes="member: 8001">So i am trying to clean all the junk off these bassani tail pipes but a standard wire brush isnt cutting it so i stepped to a wire wire drill attachment to knock off the rust and crap....here is my question.... Since i am taking off a little bit of metal, will i be removing any coating on tailpipes which protect them of the outside or can i grind alway without worrying about rust occurring faster?if someone could get my an answer ASAP that would be Super Awesome because if these pipes are too much of a hassle to grnd down then i will just drive to bassani and buy 2 new tailpipes since they are 15 mins awayThanks</blockquote>