Bracket question...

[BlackCobra50]

Where can I get a new bracket (circled in pic)? Mine is cracked and I don't like the way it looks...

(This is OnyxCobra's engine btw :thumbsup

[attachment deleted by admin]

 

[Paul]

eBay has them from time to time.  Or junkyards.  They usually bring pretty decent money.

I have two complete sets in the garage.

Paul.

*edit*

Here's a chrome powdercoated one for $105.

http://cgi.ebay.com/ebaymotors/94-95-Mustang-CHROME-coated-AC-Power-Steering-bracket_W0QQcmdZViewItemQQ_trkparmsZ72Q3a1205Q7c66Q3a2Q7c65Q3a12Q7c39Q3a1Q7c240Q3a1318Q7c301Q3a1Q7c293Q3a1Q7c294Q3a50QQ_trksidZp3286Q2ec0Q2em14QQhashZitem320344275586QQitemZ320344275586QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

 

[BlackCobra50]

eBay has them from time to time.  Or junkyards.  They usually bring pretty decent money.

I have two complete sets in the garage.

Paul.

*edit*

Here's a chrome powdercoated one for $105.

http://cgi.ebay.com/ebaymotors/94-95-Mustang-CHROME-coated-AC-Power-Steering-bracket_W0QQcmdZViewItemQQ_trkparmsZ72Q3a1205Q7c66Q3a2Q7c65Q3a12Q7c39Q3a1Q7c240Q3a1318Q7c301Q3a1Q7c293Q3a1Q7c294Q3a50QQ_trksidZp3286Q2ec0Q2em14QQhashZitem320344275586QQitemZ320344275586QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

How do you replace it? I've attempted it before but I couldn't get the power steering pulley off.

 

[Paul]

You need a power steering pulley remover.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=66412

 

[BlackCobra50]

You need a power steering pulley remover.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=66412

How the hell do you use that? lol sorry never done it before =)

 

[OnyxCobra]

you can loan the tool from Autozone for free, too. You put it over the lip on the front part of the pulley and it pulls it off as you tighten the shaft down. It's hard to explain you kinda just have to do it. I didn't pull mine all the way off but i got the pulley about half off and was able to get a wrench in there. Stupid idea on fords part, would it have been that hard to make a hole for a socket??

 

[Paul]

Clamshells close over the lip on the pulley and the puller nut with the jackscrew installed. Collar goes over the clamshells. Turn jackscrew and it will bottom out against the power steering drive, and pull the pulley off.

With an impact wrench it takes about 30 seconds.

 

[OnyxCobra]

thanks Paul, i was struggling to figure out how to word that lol

 

[BlackCobra50]

Thanks guys! :thumbsup: