Reply to thread

Message: <blockquote data-quote="delling3" data-source="post: 1440547" data-attributes="member: 22616"><p>Doing some routine maintenance chores - including changing the air filter.  Decided I would pull and clean the MAF sensor while in there.  The studs that hold the sensor to the air cleaner cover are turning - I can't loosen the nuts.  Looking at the other side, it appears that there is a cover held on with some small torx screws.  I don't have the torx bit to remove the cover, and I am not sure that I would have access to the hot-wire resistors to clean them if I remove the cover.  I am kinda stuck at the moment.  Suggestions?</p></blockquote><p></p>