svt slobra
Well-Known Member
ok guys,
today i got a trick flow intake plenium and throttle body. after installing it on my 2000 gt, it seems to have an idle hang issue and a stalling issue at stop lights. i cleaned the egr,replaced the vac lines and made sure everything was sealed. drove the car around the block and its still acting up. it also runs rich i believe(little bit of a backfire/pop on shifts)
this set up worked flawlessly on my black gt, so i really doubt its the plenium or TB....but my car did run good before i installed these
could an o2 sensor cause this? i had a cel turn on for a min and then go out the other day. ran the stored code and it came back as bank 1 sensor 1 malfunction.
and issue number 2.......
for some reason i have no cluster or heater control lights with the dimmer switch......all controls work great and guages all work.....any ideas on that?
today i got a trick flow intake plenium and throttle body. after installing it on my 2000 gt, it seems to have an idle hang issue and a stalling issue at stop lights. i cleaned the egr,replaced the vac lines and made sure everything was sealed. drove the car around the block and its still acting up. it also runs rich i believe(little bit of a backfire/pop on shifts)
this set up worked flawlessly on my black gt, so i really doubt its the plenium or TB....but my car did run good before i installed these
could an o2 sensor cause this? i had a cel turn on for a min and then go out the other day. ran the stored code and it came back as bank 1 sensor 1 malfunction.
and issue number 2.......
for some reason i have no cluster or heater control lights with the dimmer switch......all controls work great and guages all work.....any ideas on that?
