HEAD HELP

[mustangspartan]

Does anyone have a step by step process of puting on heads on a 95gt Im looking at a set of trickflows but i want to know if i can do it all with a craftsman set and a torque wrench..any step by step pics or a vid would help alot.

 

[quickstang_1994]

yep, just undo the ps, alt......then the intake and unbolt them and replace. its really easy just replace with new head bolts. make sure you have extensions

 

[mustangspartan]

so when i get the heads get new studs too?? Will the heads come with installation instructions as in torque specs and what not. Is there a certain patern to follow when tightening them down.

 

[quickstang_1994]

i would do arp bolts because studs make it hard to put the heads on. yes they have to be torqued in a certain pattern

 

[gopanoz]

Did the head on My Jeep CJ 7. Really kind of easy even on a mustang. Just take your time and make sure you do good prep work to the head and block surface and torque everything back to spec. Make sure and blow out the head with air. Particles from shipping have been know to work their way around inside during shipment.

What are you going to do with your old heads?

Has anyone had any parts or heads extrude honed? Probably need to start a new topic for this issue.

 

[mustangspartan]

I might give them to my buddy for 50 bucks and i think hes going to rebuild them with a port job and the were going to swap for his stock ones..Either way ill have a set of stockers for sale in the future if someone needs them.. First want to be a little more confident to do this myself and to not only my car but my buddies so any info guys is going to help me out alot..