HELP!!!!! engine missing after plug wire swap

PinkieT

Well-Known Member
Joined
Jun 22, 2015
Messages
2,536
Reaction score
1,002
Location
Cleveland
98 GT, stock under the hood when I got it last fall. Added CAI, ran fine. Added aftermarket coils, ran even better than before.

Just tried to install new plug wires. Found out the hard way they were the wrong length :mad:, so had to put the old ones on. Had no diagram, so got one off the internet. Car would sputter but not start. Got CORRECT diagram off the internet :angry4:, car fired right up.

That was yesterday. Today, wanted to take a drive. It ran rough once in gear and popped a bit in the exhaust. I checked the wires with an old inductive timing light - all flashed, but some only near the plug and not near the coils. ????? Got old school tester out, goes in line between the coil and plug and flashes on each pulse. Had to put it at the coil end because I couldn't get it to all the plugs, but all flashed.

The backfire indicates to me that a cylinder is getting fuel but no spark, but all the plugs seem to be getting spark. Now what???????
 

96blak54

Moderator
Staff
Joined
Feb 21, 2011
Messages
10,043
Reaction score
2,884
Location
In the shop
So...the car was running fine, you swapped plug wires and now it wont run good?
 
OP
OP
PinkieT

PinkieT

Well-Known Member
Joined
Jun 22, 2015
Messages
2,536
Reaction score
1,002
Location
Cleveland
Damn! I thought I deleted this post. Turns out I had two wires in the wrong posts on the passenger side coil. Flipped them and it ran fine.
 

Latest posts

Forum statistics

Threads
77,521
Messages
1,504,257
Members
14,989
Latest member
alleghenyamerican

Members online

Top