Deceptive GT
Active Member
Hey guys and gals, new guy here. I have been on SVTPerformance for a bit, Corral, and **********. I have a few Fords at the house. My wife's ride is a 11 Focus SEL. My daily when the weather is cold, wet, when I need to haul parts, stuff for the house, or for hunting is my 11 Ranger Sport 4x4 Xcab. When the weather is nice, I ride my 09 FZ6R to save gas.
On to why I am here. I have had a 02 GT Vert, Mineral Gray, for a few years. The build has changed directions many times. Due to my recent purchase, I think it changed for the last time. My plan is a built Teksid bottom end, TF 44cc Heads, TF Track Heat Intake, T56 Magnum, built rear, full stereo, and a Vortech V1 Si to ram air into it. Looking to make 550+ on it.
My my recent purchase is a 96 Cobra, Hyper White, original Crystal White car that needs lots of love. The car has over 200k miles on it. The plan for it is to use the C Head swap parts I was going to use for a 4V swap in my GT, a built Teksid block, T56 Magnum, a V7 JT (the V1 Si until the GT is ready for it), repaint, built rear, etc.... Looking to make over 650hp on this one.
Both cars are going through a restoration process of sorts. I want them to look better than when they came off the factory line.
On to why I am here. I have had a 02 GT Vert, Mineral Gray, for a few years. The build has changed directions many times. Due to my recent purchase, I think it changed for the last time. My plan is a built Teksid bottom end, TF 44cc Heads, TF Track Heat Intake, T56 Magnum, built rear, full stereo, and a Vortech V1 Si to ram air into it. Looking to make 550+ on it.
My my recent purchase is a 96 Cobra, Hyper White, original Crystal White car that needs lots of love. The car has over 200k miles on it. The plan for it is to use the C Head swap parts I was going to use for a 4V swap in my GT, a built Teksid block, T56 Magnum, a V7 JT (the V1 Si until the GT is ready for it), repaint, built rear, etc.... Looking to make over 650hp on this one.
Both cars are going through a restoration process of sorts. I want them to look better than when they came off the factory line.
