nother pi intake question, please repost fast

[Jrgunn5150]

wanna be cheap? go get some felpro gaskets from your local parts store and 3 ft of 5/8s" heater hose. and of course silicone, 40 dollars :dunno:

Exactly, cut the line where it comes out of the nipple and in the rear, worked fine for me for year's.

 

[nesqwick_05]

wanna be cheap? go get some felpro gaskets from your local parts store and 3 ft of 5/8s" heater hose. and of course silicone, 40 dollars :dunno:

Exactly, cut the line where it comes out of the nipple and in the rear, worked fine for me for year's.

u did the heaterhose method too , dont see why people say not to use it, coolant flows from the radiator to the motor with heater hose, why cant it go elsewhere :idiot2:

 

[Jrgunn5150]

Yep, but it does get a little squished up against the block, never caused an issue though.

 

[Willis_98GT]

wanna be cheap? go get some felpro gaskets from your local parts store and 3 ft of 5/8s" heater hose. and of course silicone, 40 dollars :dunno:

k, but which felpro gaskets should i get??

 

[nesqwick_05]

the ones for a 99-04 mustang gt... i dont know the part number, tell them you need them for a 03 mustang gt lol. thats what i did...

 

[nesqwick_05]

and if u go with the heater hose, be sure u get some clamps on it. i was helping a kid do it one time and he tried putting the manifold on without clamping the heater hose... :idiot2:

 

[Willis_98GT]

all right,

so if i already have the alternator bracket. then i'll need

99-04 gaskets
5/8 heater hose w/ 2 clamps
some bad ass silicone
and some beer?

anything else?

 

[nesqwick_05]

that should be it, pick up some extra coolant and begin wrenching... and did u tap the intakes cross over?if your nonpi has the cross over you can use the one off of it

 

[Willis_98GT]

it already has a hole by the thermostat housing. i need to get some pics of it up on here because i'm still not sure if its even pi to begin with..

 

[nesqwick_05]

should be 2 holes, one by the housing(driverside) and then in the same location on the passenger...

 

[Willis_98GT]

well ok.. yeah theirs also a sticker in there that i just found today since i took the newspaper out of the inside of the box. it says dorman manifold company blah blah. so yeah voidfinger was correct. he said that their is intergrated gaskets on on ports if its a dorman intake, so does this eliminate the use of gaskets?

so i would just have to get some heater hose and silicone and go at it??

 

[xsoutherngun89x]

is this what yours looks like?

http://i4.ebayimg.com/06/i/000/c3/58/a9f2_1_sbl.JPG

 

[Willis_98GT]

yeah i think i'm not sure i'm not at home and its in my room. and if you can find a picture of the bottom, it has indivdual gaskets in every bottom port. i'm not sure..

 

[nesqwick_05]

yes, no gaskets...

 

[Willis_98GT]

so should i just bead every port with rtv?

and yes its dorman 615-175

 

[xsoutherngun89x]

only places that need it are the cooling ports

make sure, you let it harden before you start the car

 

[Willis_98GT]

all right i'm doin this shit monday then.