one peice headlight

[GT Rob]

Dose anybody have one piece headlights on there 94'95 like to see them on

 

[Twista]

Mr. Droptoppony

 

[Slykin]

That actually looks very good.. wouldn't mind a side angle though.

 

[MustangChris]

i like them.

 

[stanger_missle]

I agree... Most one piece headlights look really dorky and out of place, but yours looks really good. I like that design :thumbsup:

 

[duh09]

I think DropTops look decent, even amazing compared to the usual one-pieces however nearly all the 2-pieces available look better than that.

I like the idea of one-pieces, I had a set of them on Bronco and they really cleaned up the front end a bit however I've yet to see ANY for the Mustang that don't look ricey.

 

[EastBayStang98]

i like them

 

[RockstarMentality]

i like the one piece look but its hard to find ones that look good on Mustangs

 

[zyzygy]

Mr. Droptoppony

I just got these in black, did you remove the corner rubber guard before installing them? mine keep falling off.

 

[T-5 Killer]

WOW those look good. I want a set!

 

[Mack]

I used to have one-piece headlights in my old V6. I thought it didn't look half bad. They didn't fit really well, though.

 

[OnyxCobra]

I like the idea of a one piece but two piece just look and fit better.

 

[switch96]

Yeah they all look like rice to me.

 

[ProKiller]

droptops' are the first one piece lights i've ever seen that look good. first time i've ever seen them before. most of them are usually projector lights or halos which just don't look right on our cars. besides the fact that most times the fitment is horrible.

 

[ttocs]

There have been many topics on this even in the last few weeks. IF you look at teh bottom of this it has links to most of those posts with teh pics you want.

 

[DropTopPony]

Mr. Droptoppony

I just got these in black, did you remove the corner rubber guard before installing them? mine keep falling off.

I did not use the rubber piece and also recessed the lights as deep as I could by tightening up the adjustment screws before installing to close any gaps. I also used extra mounting clips to secure them in. The clips that come on the factory lights (1 on each side) can be used on all the adjustment points to really secure them. I found them at latemodelrestoration.com