Sattin or black interior trim?

[NCMystic]

i don't like the brushed billit interior trim, was wondering if anyone makes the buttons and whatnot in a sattin finish or in black anodized? worse case scenario i could have the polished or brushed stuff bead blasted i guess? but at the amount of efford i'd just leace it stock

on another though process if i installed some 2000 explorer limited window switches that light up could i just tie into the window motor power wire and plice the connectors from the stock harness onto the new buttons?

what do you all think

 

[joekd]

Explorer buttons have a completely different harness, I have one in my garage and have posted pics of it before

 

[NCMystic]

could the harness connector not be cut off of the explorer buttons and replaced with the mustang harness connector or are the wire completely different as well (aside from the extra power wire on the explorer buttons i assume)?

 

[JonBeast]

Leave the buttons alone...focus on your suspension :thumbsup:

 

[blkmcnasty]

^^^^ROTFL, i agree

 

[DropTopPony]

I have been seeing a lot of black billet interior pieces. Check UPR etc...

 

[NCMystic]

going to throw some adjustable coil overs on the front at the time of the motor build. also weld in torque boxes and full length sub frame connectors, c/c plates and thinking about a torque arm out back. saleens will close that gap up a little too :thumbsup: not slamming it down though, it's intended to be a daily driver and i start throwing things at other things if i scrape the paint on my front bumber cover . . .

back to the buttons . .. i'm going to a pull apart junkyard for a new interior soon so i'm trying to figure this thing out. i know there will be some newer explorers there and it really would be nice for the arrows and lock button to light up at night, you know it too. don't even try to lie