Reply to thread

Message: <blockquote data-quote="lking78" data-source="post: 1588396" data-attributes="member: 32586">i have not given up -- the sequential lights fit my 2001 cobra and work about half way -- i replaced the old 6 pin connector with something newer on both sides -- the issue is still 5 wires from the car -- 4 wires to the sequential lights -- they respond correctly to the turn signal but if you apply the brakes -- all lights come on -- looking at schematics for a 2001 mustang, page 90-1 turn/stop/hazard lamps -- follow the brake light dark green wire to S323 where it splits -- for the cobra DG goes directly to the rear lights -- for a standard mustang (except cobra on the schematic) -- the DG goes to pin 511 of the multifunction switch -- then to the rear lights -- so my plan is to find those 2 DG wires in the dash -- put bullet connectors in them -- take 1 out of the system -- run the other to the MFS and hope i can shove it in pin 511 -- any suggestions, comments, advice -- to include -- "you are nuts" -- sincerely appreciated -- larry</blockquote>