OP
OP
Boostr1
Active Member
Ah ok, gotcha. Hm see if I can find a new one.
Slip Yoke Rubber Ring
- Thread starter Boostr1
- Start date
OP
OP
Boostr1
Active Member
No just was a rando pic for reference.
RAU03MACH
Legend
That will trash it if it becomes unbalanced
That's why I say your there replace it
OP
OP
Boostr1
Active Member
Yeah, but that whole assembly is pricey. I'll search around.
RAU03MACH
Legend
Are you trying to get the whole drive shaft
I would just get that damper with new input shaft
OP
OP
Boostr1
Active Member
No just the yoke with the damper
OP
OP
Boostr1
Active Member
Don't feel like going to the garage and measure sooo what length is the slip yoke for the 98 4R70W, 7.5"?
Gonna order the Sonnax slip yoke, install it and get the whole drive shaft balanced.
Gonna order the Sonnax slip yoke, install it and get the whole drive shaft balanced.
RAU03MACH
Legend
You having a hard time getting the part
Or just going a different route
Or just going a different route
OP
OP
Boostr1
Active Member
Different route. Those yokes are pretty pricey. I figured I get the better Sonnax piece and balance for about the same price.
RAU03MACH
Legend
I hear you
Prices have went up on everything
OP
OP
Boostr1
Active Member
Are these the same, they seem to be to me with the same part number, but their measurements are throwing me off. My stock slip yoke measures 7.5” from end to end.
https://www.summitracing.com/parts/sox-t2-3-14061hp
https://www.jegs.com/i/x/852/T2-3-14061HP/10002/-1
https://www.summitracing.com/parts/sox-t2-3-14061hp
https://www.jegs.com/i/x/852/T2-3-14061HP/10002/-1
Those should be the same piece. The Jegs link has it measured from the u joint center line to the end and summit doesn’t have that listed. But summits 6.63” measurement is the same as Jegs centerline measurement. I would say they are the same.
OP
OP
Boostr1
Active Member
Thanks, so this would be the correct one for a "stock" replacement for my application?
I believe so.
