What is this connector for??

[AaRoN]

I was unhooking the EGR valve and seen it just sitting there. Never noticed it before... :dunno:

 

[Jrgunn5150]

It's a ground that belongs on that stud of the fuel rail there.

 

[AaRoN]

Ok...lol...that's what I assumed it was.

About those codes.....?

 

[Jrgunn5150]

Right, get me a pic of the other side and I'll show you.

 

[AaRoN]

 

[MustangMatt96GT]

arron did you paint your Valve Covers too?

 

[AaRoN]

arron did you paint your Valve Covers too?

Yeah. When I did the motor swap. They look like ass now though from the install. No way am I taking them off to repaint them.

 

[Jrgunn5150]

The second pic is the solenoid, I dunno what the third thing is.

 

[AaRoN]

The second pic is the solenoid, I dunno what the third thing is.

Ok, so that's the evap solenoid.

 

[MustangMatt96GT]

yea my valve covers had black spots too from installing them. Im going to powdercoat my next set...

 

[AaRoN]

yea my valve covers had black spots too from installing them. Im going to powdercoat my next set...

They look nowhere near the way they did before the install.

 

[AaRoN]

The second pic is the solenoid, I dunno what the third thing is.

The thing in the 3rd pic is the EVAP Canister Purge Regulator. That will also throw a P1443.

I'll see if my CEL comes back on. If it does, then I need to replace that cannister. $55 from AAP. The sensor is about $23 but, I think I cleaned it out good enough. We'll see though.

Purge Flow Sensor or Vapor Cannistor Purge Valve Part # F57Z-14A606-BA (Pic #2)
Purge Flow Cannister/Solenoid Part # E4ZF-9C915-AA (Pic #3)

 

[Petek]

ohh man the stupid p1443 plagued my car for like 2 months. it ended up being the purge regulator, i replaced that, and it fixed the problem.

 

[AaRoN]

ohh man the stupid p1443 plagued my car for like 2 months. it ended up being the purge regulator, i replaced that, and it fixed the problem.

I found out the real reason for the P0401 too. It wasn't because the EGR was dirty, it was because 2 of the vacuum hoses were switched around.

 

[Black97GT]

bumpin this thread...my fucking P1443 won't go away

I replaced the sensor...I think I need the actual cannister. However I can't find it on NAPA or AAP's website...any suggestions?

 

[AaRoN]

bumpin this thread...my fucking P1443 won't go away

I replaced the sensor...I think I need the actual cannister. However I can't find it on NAPA or AAP's website...any suggestions?

I replaced my purge valve and my CEL came back on. I :dunno: what it is.

 

[scarface]

I say delete it all and have a tuner cut that cel off.

 

[AaRoN]

I say delete it all and have a tuner cut that cel off.

Yeah, I'm just gonna turn off the CEL when I get my handheld.

 

[scarface]

now you are talkin.

 

[Knuckles281]

yep, tuner FOR THE MUTHER EFFIN WIN