$12,500 OBO.
'03 Mach 1
92k miles
Non-IUP car - interior is nice, except for wear on seats(usual bolster wear for age/miles)
car was repainted 2 years ago after it got keyed. few rock chips since.
has smoked headlights and taillights. have stock lights if desired.
mods:
Engine(about 20k miles):
Built by HPP racing and made 368hp/350tq on motor before ported intake and BBK throttle body.
Cobra iron block
Cobra crank
Manley H-Beam Rods
J&E pistons (very close to stock compression)
lightly worked heads
Crower Stage 2 cams
ported intake manifold
BBK 65mm twin throttle body
JLT RAI
SCT flip chip(only one tune currently)
has head cooling mod done.
Exhaust: BBK long tube headers
BBK off-road x pipe
bassani cat-back
EGR deleted.
Trans(about 10k miles):
Pro Motion Performance built 3650 transmission(700+ rated)
spec stage 3+ clutch
AFM aluminum Flywheel
MGW short throw shifter
Rearend(less than 5k miles):
Auburn pro 31 spline posi
Motive 4.10 gears
Superior 31 spline axles
Suspension:
UPR double adj. upper control arms
HPM Megabite Jr. lower control arms
Eibach drag springs in front
stock Mach springs in rear
front sway bar not currently installed(have)
'03 Cobra tank and pumps
wheels can be worked into deal. i currently have:
chrome 17x9/10.5 03 Cobras.
black/machined lip 18x9 03 cobras. pair of all black 17x9 cobras w/ 275/40 NT05R's.
will soon have stock mach wheels with 275 555R's in back. and a pair of 17x10.5 stock finish reps.
about all i can think of.
here's a few pix.
'03 Mach 1
92k miles
Non-IUP car - interior is nice, except for wear on seats(usual bolster wear for age/miles)
car was repainted 2 years ago after it got keyed. few rock chips since.
has smoked headlights and taillights. have stock lights if desired.
mods:
Engine(about 20k miles):
Built by HPP racing and made 368hp/350tq on motor before ported intake and BBK throttle body.
Cobra iron block
Cobra crank
Manley H-Beam Rods
J&E pistons (very close to stock compression)
lightly worked heads
Crower Stage 2 cams
ported intake manifold
BBK 65mm twin throttle body
JLT RAI
SCT flip chip(only one tune currently)
has head cooling mod done.
Exhaust: BBK long tube headers
BBK off-road x pipe
bassani cat-back
EGR deleted.
Trans(about 10k miles):
Pro Motion Performance built 3650 transmission(700+ rated)
spec stage 3+ clutch
AFM aluminum Flywheel
MGW short throw shifter
Rearend(less than 5k miles):
Auburn pro 31 spline posi
Motive 4.10 gears
Superior 31 spline axles
Suspension:
UPR double adj. upper control arms
HPM Megabite Jr. lower control arms
Eibach drag springs in front
stock Mach springs in rear
front sway bar not currently installed(have)
'03 Cobra tank and pumps
wheels can be worked into deal. i currently have:
chrome 17x9/10.5 03 Cobras.
black/machined lip 18x9 03 cobras. pair of all black 17x9 cobras w/ 275/40 NT05R's.
will soon have stock mach wheels with 275 555R's in back. and a pair of 17x10.5 stock finish reps.
about all i can think of.
here's a few pix.
