5.0 Harness Help :(

[E36x302]

Hey there, as you can tell I'm new to here. I wont bother you with telling you about me, lets get down to the nitty gritty.




i have a 1992 BMW 325I sedan, i also have a 1995 SN95.0, with 32k original


you see where im getting with this? good.


Engine is installed
Transmission installed
Drive shaft chopped
now hydraulic slave


what im stuck on is simple, yet terrible.




i need the harness obviously, just how much can i thin out?? id rather not run all 40lbs of harness, i was curious if these were anything like the nissans, where you hack everything out and just run the MAF directly to the ecu??


delete the EEC and such, basically just ecu and necessary wiring, my issue is i dont know what these 5.0s find necessary!!!


any advice help or diagrams would be greatly helpful!!!!

 

[ttocs]

what computer are you using?

 

[E36x302]

looks to be T4M0

 

[E36x302]

if i circumvented the CCRM since all of the bmw features are switch controlled. would this work? im more attempting to delete 90 of the bulk of the harness