A "How Much Will it Make" Thread

[rz5.0]

Eh for shits and giggles.

Ill request 2 setups

My current setup that has yet to be put together but I have all the parts:
CompCams stage 1 thumpr flat tappet cam
CompCams pushrods
1.7 pedestal roller rockers
Truck Flow valve springs
Ford racing hydraulic lifters
MSD cap and rotor
Mad coil pack
CAI
ford racing spark plug wires

And then my end goal for next summer:
All the above
On3 performance turbo
24#injectors
75mm throttle body
90mm MAF
340lph fuel pump
Tune


Sent from my iPhone 5 using Tapatalk

Why a flat tapped cam.
24 too small. .

 

[FivepointSlow]

Why a flat tapped cam.
24 too small. .

Idk why I typed 24....
I meant 60. Lmao. 60# injectors

Flat tappet cam was cheap used so I decided to go with that. Hydraulic lifters I have are for flat tappet cams aswell so everything matches up.


Sent from my iPhone 5 using Tapatalk

 

[rz5.0]

I would go roller my self.. not sure how that's going to work.. flats wear out faster with today's oil.. push rods will change size. .

 

[FivepointSlow]

By the time I put a turbo in I will probably have switched to a roller. I am aware that flat tappets cause wear.


Sent from my iPhone 5 using Tapatalk