Bit the bullett

[97stanger]

Well after making hundreds of calls around for the Crower Stage II blower cams, an interesting story came up. Just so happens the cams are discontinued now, and crower had one set left sitting on the shelf. Soooooo, I bit the bullet and ordered them. Only thing left now to order are the valve springs/steel retainers. Other than that, my dad and I will be doing the install and I will just get a retune. Hoping for 410-420rwhp/410+tq. Now when this will all get done, not really sure. May not do the install until after the summer passes.

 

[duff daddy]

sweeeeeeeet, dont screw em up installing lol i hear they are hard to find )

 

[97stanger]

got the last set thanks for the encouraging words lol.

 

[vermilion]

i have the pi version i went with manley valvetrain. .580 springs and titanium retainers. coil bind is about an inch. i hear they make a great idling sound.

 

[mikey94gt]

sweet. hope it runs like a banchee!!!

 

[Win]

pics and vids are a necessity

 

[97stanger]

well like I said I probably won't get to it until the end of the summer before I put her away for the winter. But I'll absolutely have vids/pics of everything. Next step is 15" rims with bigs/skinnies and some track times!

 

[duff daddy]

lol slicks and skinnis sound fun haha

 

[97stanger]

heck ya!

 

[OnyxCobra]

congrats dude, cammed 4.6s sound so sexy

 

[94darkhorse]

Nice! :thumbsup:

 

[US Soldier(stang 98)]

sweet shit man

 

[97stanger]

cams will be here tomorrow!! wooooo, now just need valve springs and steel retainers and it should be a whole new animal. can't wait

 

[DropTopPony]

You doing the install yourself?

 

[19mustang95]

why didn't you just order cams from someone else? there are a few other companies that make some really great cams...

 

[97stanger]

i have done my research for years on non pi cams. These were the absolute best cams somebody could put in a car with a setup like mine.

 

[97stanger]

oh yeah, got them today! can't wait to do the install. and yeah bob I am doing the install. next step is the valve springs and steel retainers though.

 

[DropTopPony]

I'd be tempted to pull those heads off and get port and valve job. Would not cost that much and would help you out greatly. Something mild should be in the price range of the cams and add nice #'s....

I love spending other peoples money....

 

[JonBeast]

NICE man...I can't wait to build my motor :headbang:

 

[97stanger]

trust me, I would love to do my heads. Keep in mind though with these cams alone I should be in the 420rwhp range through an auto and high stall that is. if I did my heads I wouldnt doubt I could be in the upper 400's. I think that may be a little too much for stock bottom end!