delling3
Active Member
So, spent a good portion of my Sunday detailing the engine bay. I took the strut tower brace and intake off to gain better access to the engine for cleaning. I had previously purchased a set of new plugs and wires, and decided it was a great time to tackle that job.
My 5/8 sparkplug socket fits my new NGK Platinum plugs just fine, but when I want to pull the first plug from the motor, it seems to be too small for the plugs that are in the engine. Pulled out a 17mm deep well socket out and it's diameter is too large to fit down into the well. WTF?
I sure some of you are just having a good laugh at this dumbshit's question, but do I need to go buy a special tool to get the plugs out?
My 5/8 sparkplug socket fits my new NGK Platinum plugs just fine, but when I want to pull the first plug from the motor, it seems to be too small for the plugs that are in the engine. Pulled out a 17mm deep well socket out and it's diameter is too large to fit down into the well. WTF?
I sure some of you are just having a good laugh at this dumbshit's question, but do I need to go buy a special tool to get the plugs out?