Chin Spoilers...

[Jnicho]

Thoughts on a chin spoiler? Car already sits low but I think it would be OK. I like how they look with the factory GT side skirts...looks like they are about the same "height"...if that makes sense.

Something like this:

 

[joekd]

Have one on my car, love it, think it will look great on your black car

 

[Ferocious]

On a black car, it's a must.

 

[Jnicho]

I was looking at photos and that's what I was thinking too. Like in my sig photo the side skirts look lower than the front air dam...I think it enhances the overall look if they are all about the same height.

 

[belber095]

especially since it's flat black on gloss black. to me, that's down right sexy. it's contrast, but it isn't obvious contrast. if you like that look, some matteblack hash marks might look good too

 

[DeepList]

I put one on my car not too long ago. Crappy picture because it's in my garage and I couldn't really back up far enough to get a good shot:

 

[whiplash473]

chin spoiler is a must on a gt bumper..especially a black stang

 

[OnyxCobra]

I say if you like it then do it.

 

[the5.ohh]

I say do it, looks awesome. I can't wait to buy one

 

[Stad95GT]

I got one on mine. It just makes the stock GT front end look sooo much better. Go for it...

 

[Mustanger]

It even looks great on a WHITE car!

 

[TanTop94]

Do it! Something I do if I want my chin spoiler to look glossy is put tire wet on it..yum yum

 

[9838stang]

does this convince you?

 

[the5.ohh]

^If that doesn't convince someone. Idk what would lol. That is the final car I needed to see, I'm gettin one lol.

 

[Jnicho]

Well I guess that was pretty cut and dry, LOL! Thanks!

 

[DeepList]

does this convince you?

Do you have yours recessed in a little bit? It kind of looks that way from your pictures.

 

[9838stang]

Yep. I have mine lined up like how the mach 1 has it from the factory. I though about putting it closer to the lip of the bumper but I wasn liking how it looked with the corners. The corners of the bumper stuck out to far. The way I have it flows really well

 

[DeepList]

Yep. I have mine lined up like how the mach 1 has it from the factory. I though about putting it closer to the lip of the bumper but I wasn liking how it looked with the corners. The corners of the bumper stuck out to far. The way I have it flows really well

That's how I ended up doing mine too. It's recessed in just a bit.

 

[98BlackGT]

has anyone done one on a cobra bumper? or do they not make them for cobra bumpers im not sure

 

[DeepList]

has anyone done one on a cobra bumper? or do they not make them for cobra bumpers im not sure

Yeah, I did mine. I posted a picture a few posts up in the thread. It makes no difference what bumper cover you have. Unless you have an OEM Mach, you're going to have to drill holes no matter what.