Gauges

stangman281v8 · Jan 27, 2009

Hey everyone. I just wanted to share what I was working on. I installed an after market head unit in my 97GT. This left the bottom din free. I decided to install Stewart Warner gauges that I had kicking around. For the gauge plate, I cut a piece of plexi and used a 2" whole saw to cut 3 holes. After cutting it and test fitted it, I wet sanded the plate with 600 and then painted it with flat black. Sorry for the bad pics

[attachment deleted by admin]

Mustangmaster77 · Jan 27, 2009

looks good, better than that little tray

Paul · Jan 27, 2009

Cool! How are you retaining it in the hole?

stangman281v8 · Jan 27, 2009

I cut the plexi a little big, so it just slides in and is held in by friction. To make sure it stays in place, I will put RTV on the edges and clamp down the plate until the RTV dries.