ThA SkInNy
New Member
- Joined
- Feb 15, 2012
- Messages
- 75
- Reaction score
- 0
I've been collecting parts for a little while now and I and getting ready to put the newer motor and trans in my 95. While I am pulling it I am going to add the parts I have and have been collecting over the last few months. Is not much but should make the car fun!
Here's a list of what will be going on:
Stock bottom end and cam 5.0
Gt40p heads (looking into roller rockers just not sure of ratio)
Gt40 explorer intake
Trick flow elbow
Trick flow under drive pulleys
Mac shorty p headers
BBK stainless O/R x pipe
MSD 6al ignition setup
Sub frame connectors
Centerforce HDX
Steeda cable and quadrant
4:10's
For exhaust I have 2 options I have a set of super 44's and a set of stainless works race mufflers from a gt500 kit. Regaurdless It will be a dumped exhaust system. I'm just not sure which ones to go with.
What compression ration can i expect with the P heads and I'm also kinda wondering what kind of power I might expect to see ...lol Any ideas or input at all is appreciated.
http://www.flickr.com/photos/43445913@N03/7674104744/
http://www.flickr.com/photos/43445913@N03/7674106062/
I posted in the intro section and had some tech questions so I just copied and pasted... Lol
I'm wanting to know what is the recommended spring to use for the setup I'm putting together... I definetaly want it to rev but I'm not sure if I'm going roller rocker orcnotvjust yet.
Any help is greatly appreciated!
Thanks
Here's a list of what will be going on:
Stock bottom end and cam 5.0
Gt40p heads (looking into roller rockers just not sure of ratio)
Gt40 explorer intake
Trick flow elbow
Trick flow under drive pulleys
Mac shorty p headers
BBK stainless O/R x pipe
MSD 6al ignition setup
Sub frame connectors
Centerforce HDX
Steeda cable and quadrant
4:10's
For exhaust I have 2 options I have a set of super 44's and a set of stainless works race mufflers from a gt500 kit. Regaurdless It will be a dumped exhaust system. I'm just not sure which ones to go with.
What compression ration can i expect with the P heads and I'm also kinda wondering what kind of power I might expect to see ...lol Any ideas or input at all is appreciated.
http://www.flickr.com/photos/43445913@N03/7674104744/
http://www.flickr.com/photos/43445913@N03/7674106062/
I posted in the intro section and had some tech questions so I just copied and pasted... Lol
I'm wanting to know what is the recommended spring to use for the setup I'm putting together... I definetaly want it to rev but I'm not sure if I'm going roller rocker orcnotvjust yet.
Any help is greatly appreciated!
Thanks