hittin the bottle!

copmagnet

Active Member
Joined
Dec 17, 2011
Messages
472
Reaction score
13
Location
moyock nc/greenbrier VA
nothing like having HP at the flip of a switch ;)

install took me two days (I'm lazy) and came out pretty clean IMHO. still need to pick up wire looms/more zipties, and some heavier zipties for the main feed line as the ones I used are kinda small and I dont trust them.

I'm also looking at new bottle brackets. the stock NOS/holley brackets are trash and it was almost impossible to mount my rear mount..Its actually only held in by one bolt..

562873_376965962359109_1839650168_n.jpg


548267_377565935632445_1546532588_n.jpg


557212_377971518925220_2051992186_n.jpg

531372_378150255574013_1964629065_n.jpg
 

FrankenStang

Well-Known Member
Joined
Jun 16, 2012
Messages
1,051
Reaction score
29
Location
bum****egypt
i ahd a zex dry kit with the management box and I LOVED IT..ran a 100 dry shot at my motor and was blowing cars out of the water..was nice being able to lay rubber doing 50 mph....GO JUICE!
 

sn95jones

Well-Known Member
Joined
May 29, 2011
Messages
4,139
Reaction score
323
Location
Arlington, Tx
Whoo giggle juice. Personally if it were me i would havr put the switch where the coin holder is instead of putting a hole on the dash but to each their own
 
OP
OP
C

copmagnet

Active Member
Joined
Dec 17, 2011
Messages
472
Reaction score
13
Location
moyock nc/greenbrier VA
nice work.
what's the next step? Tuning?
how's it drive?

I'm not oing to tune until I can figure out what system I want to go with.

my window switch should be here tomorrow...
purge whenever I feel like ordering it...

I want a system that will allow me to have an advanced timing, but will automatically retard the timing when I arm the system. I was thinking a bama/SCT chip with the flip switch, but I have always heard to avoid chips.

still drives pretty good. hasnt technically left the garage yet. I'll most likely be filling the bottle friday and running some "safe-shot" 30 hp jets until I get my tuner/chip/whatever I do.
 

96TANGERINEGT

Well-Known Member
Joined
Sep 21, 2011
Messages
2,704
Reaction score
204
thats awsome, looks good . i need a kit like that. that orange bottle would look badass in the trunk of my car.
what shot r u gonna run with it ?
 

SVTurbo 98

Active Member
Joined
Aug 19, 2009
Messages
442
Reaction score
1
Location
Santa Rosa Beach, FL
Nice you're going to want a bottle heater to keep the bottle pressure consistent. You'll notice a huge difference between spraying at 850psi vs. 1050psi. Where did you put the wot switch? Its good to here you're getting a window switch...you're going to have a lot of fun with it
 

FrankenStang

Well-Known Member
Joined
Jun 16, 2012
Messages
1,051
Reaction score
29
Location
bum****egypt
my buddy has an sct and has a nitrous setting for it...but i personally ran mine w/o a custom tune and had no isses..but it was only a 100 dry and i had copperplugs,race fuel, and my handheld superchips tuner atleast....
 

Musturd

Post Whore
Joined
Feb 12, 2011
Messages
11,224
Reaction score
3,674
Yea I run a diablosport 4 bank chip with a street a tune race tune and spray tune. Might do a c16 tune for this year as well
 
OP
OP
C

copmagnet

Active Member
Joined
Dec 17, 2011
Messages
472
Reaction score
13
Location
moyock nc/greenbrier VA
Nice you're going to want a bottle heater to keep the bottle pressure consistent. You'll notice a huge difference between spraying at 850psi vs. 1050psi. Where did you put the wot switch? Its good to here you're getting a window switch...you're going to have a lot of fun with it

a bottle heater is on the list of things to get. My

WOT switch is in front of my pedal.

I am going to be running a 75 or 100 shot..not sure yet..

548028_378344978887874_1899142716_n.jpg
 

ttocs

Forum's #1 poster
Joined
Oct 9, 2009
Messages
37,643
Reaction score
7,761
Location
Evansville Indiana
I made a switch bank in the ashtray myself.

I think you are confusing the bama chips with a tune. You can get a 3 bank chip and have it dyno tuned and it would be fine but you need to turn the motor off before you flip from one setting to the other. Its the same chip bama uses but your tuner will put a tune for your car on there.
 

Marvin97

Well-Known Member
Joined
Mar 20, 2008
Messages
1,137
Reaction score
19
Location
Glasgow, Ky
Glad to see you got the kit on, be sure and change the plugs to some NGK Tr6's, don't spray it on a platinum plug!
 

RichV

Well-Known Member
Joined
May 6, 2012
Messages
4,230
Reaction score
254
Location
CO
Sweet! Love running the spray.

Get the purge as soon you can, on the 1st spray, you will get nothing but fuel right into the intake until the nitrous catches up. Bad things could happen.
 

Forum statistics

Threads
78,533
Messages
1,535,704
Members
16,186
Latest member
Armand

Members online

Top