Hydraulic Clutch issues

[Adfalenski]

Double check the connection between the master cylinder linkage and the brake pedal. Too much slack can also cause engagement problem.

 

[07GtS197]

I adjusted the firewall adjuster to take out the slack. It’s weird because the clutch is inconsistent. I went out to move it and it acted like normal though I’m sure it’s still screwed up. Someone on another forum said it could be air but I bled it more than once and it made no difference.

 

[RAU03MACH]

Ok I’m starting to get sick of this clutch. I bled it and got some air out but it didn’t help at all. What happens is the first time I push the clutch to the floor it’s wide open, I put it in gear and slip the clutch then push it in again. This time it won’t release all the way. I can see the rpms are a little lower and I can hear the transmission making a whirring sound so I know it’s not engaging all the way and dragging. How is this happening?

That thing would be in a trash can cut up into tiny little pieces
the first round

 

[07GtS197]

Lol it’s about to be. All the stuff to convert it back to a cable setup is on its way just in case. Hopefully I’ll figure it out soon.

 

[RAU03MACH]

that clutch cylinder is a pain in the ass
i did have a car that had one when it went out i took it out , bleed adjust bleed adjust bull shit

 

[07GtS197]

I adjusted the firewall adjuster two clicks out and it seems be be better. I’ll keep my eye on it.