Name that modular part and its installed location
Win bragging rights!
Win bragging rights!
Name that modular part!
- Thread starter 96blak54
- Start date
ttocs
Forum's #1 poster
modular butt plug.
OP
OP
Close, but no.
07GtS197
Well-Known Member
Coolant plug on the sides of the block?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Cylinder head oil galley plug.
OLD H2S
Well-Known Member
front of block oil plug.
Yes
OP
OP
OP
OP
ttocs
Forum's #1 poster
Your butt plug........
OP
OP
My butt doent work.....so no.
ttocs
Forum's #1 poster
I thought mine was the only one....
Threaded rotary thermisticator!
01yellercobra
Active Member
- Joined
- Feb 23, 2018
- Messages
- 628
- Reaction score
- 193
Is that one of the restrictor plugs?
ttocs
Forum's #1 poster
I am pretty sure he has said it is not a butt plug now already.
Wobulating wavmometor
OP
OP
A very good guess! And it does appear to be a restricted type plug given the thick bottom, but i dont believe restricting oil passage in this area is needed. Its a dead end.
OP
OP
OP
OP
Here you go modular maniacs.
Most of you guessed its application, but not location and for good reason.
This is the first time ive seen an oil plug look like this from a modular head. Its use to plug the oil gallery where the timing tentioner actuator resides. You see, the heads are interchangeable left or right side and is completely machined to be used for either side. All thats needed is to insert the all plugs in the correct location. This plug in particular caps off the tentioner oil supply passage on the rear of the head.
I find it odd the plug to look this way, cause its the first ive seen, but given most of the mod heads i have laying around are pre-02 and these are '09.
After inspecting why the plug looks like a restrictor, im still clueless.
Most of you guessed its application, but not location and for good reason.
This is the first time ive seen an oil plug look like this from a modular head. Its use to plug the oil gallery where the timing tentioner actuator resides. You see, the heads are interchangeable left or right side and is completely machined to be used for either side. All thats needed is to insert the all plugs in the correct location. This plug in particular caps off the tentioner oil supply passage on the rear of the head.
I find it odd the plug to look this way, cause its the first ive seen, but given most of the mod heads i have laying around are pre-02 and these are '09.
After inspecting why the plug looks like a restrictor, im still clueless.
Silver95bird
Active Member
- Joined
- Sep 5, 2016
- Messages
- 494
- Reaction score
- 113
is this found only on modulars which use plastic tensioners?
Sent from my moto z3 using Tapatalk
Sent from my moto z3 using Tapatalk
