New to Forum V6 Eaton SN95 owner

[Roadhawg]

New to forums...........................
Here is my 1995 v6 Mustang

 

[94darkhorse]

Nice! What kinda power dose it have. Welcome to the site.

 

[v6mustang94]

Very nice. I would also like to know the numbers.

I'm planning out a m90 4.2 to swap in near the end of winter. Any suggestions? My build thread is stickied but I haven't updated it much lately. I'm pretty much at the point where all I need to do is get the block work done and then start piecing it together.

 

[Lightning Struck]

DAMN !!! very clean looking install there..........more pics please, and numbers would be nice too

 

[AaRoN]

Welcome! Nice looking bay :coolsmiley:

 

[Lightning Struck]

Welcome! Nice looking bay :coolsmiley:

I bet his 6 is stronger than your 8 :uglystupid2:

 

[Dalamar]

Nice setup.

Welcome to the forums.

 

[Javi]

Welcome

that is nice

 

[red97stang]

welcome

 

[justinschmidt1]

Did you do the split port swap?

whats the thing run>

 

[v6mustang94]

Did you do the split port swap?

whats the thing run>

The m90 is a single port setup. The lower intake manifold requires the single port heads.

 

[vermilion]

DAMN !!! very clean looking install there..........more pics please, and numbers would be nice too

i agree with you b.

 

[Lightning Struck]

DAMN !!! very clean looking install there..........more pics please, and numbers would be nice too

i agree with you b.

and yet..........were STILL waiting for both :nonono: :nonono: :nonono: where is this guy at?? I want some more info on his ride.

 

[v6mustang94]

I wish he stuck around more as well. I'm doing the same damn thing to my car.

 

[voidfinger]

New to forums...........................
Here is my 1995 v6 Mustang

dude that looks so nice... even has an 8 rib set up. I've always wondered though, what is the pipe on the drivers side and where does it go??? man, makes me want to get a dd v6 and put one on there

 

[1slosn95]

the pipe on the drivers side goes to the intercooler and i believe he stays on 3.8mustang.com and v6power.net more then anywhere else but not sure

 

[v6mustang94]

the pipe on the drivers side goes to the intercooler and i believe he stays on 3.8mustang.com and v6power.net more then anywhere else but not sure

Who is he on 3.8? I've never seen that engine bay before...

 

[1slosn95]

idk but i remember him on there i think he goes by the same name. I haven't been on there in forever i need to get on.

 

[Roadhawg]

DAMN !!! very clean looking install there..........more pics please, and numbers would be nice too

Thank You,

I had my car Dyno tuned and my numbers are after it was on the Dyno for about 1.5 hours. (343rwhp 420rwtq)
I did a bit more cleaning in the engine bay.

 

[voidfinger]

wow thats freaken awsome