Plug gap for 6-8PSI?

[94svtturbo]

Anybody got any recommendations as to what plug gap i should run for 6-8PSI so I dont blow out the spark under boost?

I just have and MSD coil and 8MM wires. so the ignition system isnt too upgraded.

Thanks

 

[sn95gtvert]

good question, i will be needing this information as well.

boosted stangs in oregon FTW.

 

[vermilion]

.036 is the usual

 

[94svtturbo]

good question, i will be needing this information as well.

boosted stangs in oregon FTW.

hell yeah!!! have you checked out the oregon/washington mustang club yet?

.036 is the usual

Sweet i gapped them a .032 when i put them in so i should be good to go. I only went one step colder than foctory too. should i go to 2 steps colder?

 

[sn95gtvert]

i know of the washington/oregon stang forum but not of a club. that forum was up and down so many times i just kinda left it behind.

 

[94svtturbo]

yeah. it was having some hosting issues for awhile but that all over now. We got a new host and site. same name tho if you wanna check it out again

 

[sn95gtvert]

i will for sure, and its finally not raining for once and we have sun today woot.

 

[96_SVT_Cobra]

i ran .032 with 14-15psi. so somewhere in that neck of the woods would be fine

 

[330CubeGt]

Anywhere from .30-.35 should be fine anywhere from 8-15lb/bst

Have any videos of the car? Just curious to see how it runs.