The info I had.
Parts needed for mustang for swapping onto a non PI 1996 4.6 2V
Two O-ring Gaskets - Heater tub Nipple
Part # (Nappa)
Mahle 72014
Part # (ford)
391533S100
- Coolant Heater tube Nipple (twin O-ring) Part#: F75z8555aa (ford genuine off AM.com)
- Can use a generic O-ring that are 49 cents each
Intake Manifold Gaskets
- What I got, MS 95728-2. This is plastic (it will work, just make sure it’s for a 99-04 mustang)
- What I need MS 98007 T-1. Steel Heavy Duty!***
-Ford Air Intake Manifolds
non PI Dorman
615178 (junky)
- PI Dorman
615175 Does not improve HP
-Ford PI Made by FRP**
M9424P46 <— what you want
HVAC Heater Pipe MOTORCRAFT Part#: KT-21
fits 99-04 Ford Mustang 4.6L-V8
Get the coolant nipple from ford if you need it
- This part is the coolant crossover needed for under the new intake to make room between cylinder heads
For making heater temp hikes in crossover
3/8 Tap (NPT type)
37/64ths drill bit
NOTE:”“Took a bit to get it installed on my non PI heads, definitely make sure you have the 99-04 coolant fitting and pipe that runs under the manifold as well as a 37 64th drill bit and taps if your converting to a non- PI motor, as well as the 99-04 gaskets which you'll want to use a bit of RTV around the coolant ports, as you'll notice a difference between the gasket and the ports.””
Injector service video
Thermostat for car
188 - 33029
180 -
Fuel Injectors
F1ZE-C2A 86-95 mustang 19lbs/hr rating