skinny problem

[scott5]

I just got draglites for my car and the backs fit fine, but the skinnys i got for the front are rubbing off the front brakes.. they are 15x3.5.. I was wondering what size spacer i would have to use to push them far enough away so they do not rub without me having to grind any of the brakes.

 

[scarface]

I just ground down the cross hair on the brakes till they cleared.

 

[ripper]

I wish my wife had this problem :angel: Anyone saves this thread and I will hunt you down.

 

[scarface]

I wish my wife had this problem :angel: Anyone saves this thread and I will hunt you down.

youve been quoted...HAHA! you cant edit my post

 

[ripper]

LMAO DIK!!!!!!!!!

 

[2slo95fiveoh]

i believe a 1" spacer is all you need to clear the brakes. post up pics when you're done.

 

[1FastGT]

shoulda gotten the rihght back spacing.

 

[scarface]

i believe a 1" spacer is all you need to clear the brakes. post up pics when you're done.

1inch is overkill. he can grind down the bracket enough to clear.

shoulda gotten the rihght back spacing.

Only one BS avalible or a 3.5 inch wide wheel.

 

[2slo95fiveoh]

i believe a 1" spacer is all you need to clear the brakes. post up pics when you're done.

1inch is overkill. he can grind down the bracket enough to clear.

i wasn't sure what brakes he was using on the front. i didn't know if he had upgraded to the 13" cobras to where
i have been told a 1" spacer is required. but he also did initially say he did not want to do any grinding, but i am not aware
of a proper spacer for stock gt brake clearance.

 

[scarface]

i believe a 1" spacer is all you need to clear the brakes. post up pics when you're done.

1inch is overkill. he can grind down the bracket enough to clear.

i wasn't sure what brakes he was using on the front. i didn't know if he had upgraded to the 13" cobras to where
i have been told a 1" spacer is required. but he also did initially say he did not want to do any grinding, but i am not aware
of a proper spacer for stock gt brake clearance.

1inch for the cobras, and its just a tiny little spacer if you dont want to grind.

 

[ryclef331]

7/16" Spacer is what I use on my GT. On a Cobra a 3/4" Spacer should get the job done.